Common questions

What happens when idle control valve goes bad?

What happens when idle control valve goes bad?

If the idle control valve fails completely, it may leave the vehicle without a source of air to maintain a proper idle. This may result in the engine stalling while operating, and in some cases may result in an engine that will not idle at all, and stalls as soon as it is started.

What are the symptoms of a bad air idle control?

Here are the most common symptoms of a bad IAC valve:

  • Check engine light comes on.
  • Rough idling.
  • Stalling.
  • Weak acceleration.
  • Fluctuating idle speed.
  • Increased idle RPMs.

What happens if idle air control valve is stuck open?

An obstructed or stuck-shut IAC will result in a rich air-fuel ratio at idle, so the engine will start very easily while cold and then die suddenly after a slight puff of black tail-pipe smoke. A stuck-open IAC might start fine while warm and may continue to run if the engine reaches high-enough RPM.

Can you drive with a bad idle air control valve?

Technically, you may be able to drive with a bad IAC—but you should not continue doing so. A bad IAC can potentially lead to stalling, which can compromise vehicle safety. Plus, you won’t pass a state emissions test if the check engine light is on due to a bad IAC.

How do I fix code P0505?

What repairs can fix the P0505 code?

  1. Replacing the IAC valve and cleaning the throttle body and passages.
  2. Removing carbon from throttle body and IAC passages and clean IAC.
  3. Repairing a vacuum leak in the engine intake manifold vacuum system or gaskets.

How do I know if my idle air control valve is bad?

Look at your dashboard; if the check engine light is on in conjunction with idle issues, it may be because the idle control valve is malfunctioning. The check engine light looks like a simple drawing of an engine. A check engine light in conjunction with idle issues can be indicative of a faulty idle control valve.

How much does an idle control valve cost?

The replacement cost of an idle control valve is anywhere from $120 to $500. The cost of the parts alone will be between $70 and $400+, depending on the make and model of your vehicle. The labor cost should only be around $50 to $100 because it doesn’t take that long to remove and replace the old idle control valve.

Can I drive with a P0505 code?

Trouble code P0505 should be diagnosed and repaired as soon as possible. Not recommended, however, you may drive your vehicle while trouble code P0505 is present unless the engine stall or stumbling is is severe enough to hinder proper vehicle operation. Erratic or lack of idle control may be noticed.

How do I fix code P0507?

What repairs can fix the P0507 code?

  1. Replacing or cleaning the idle air valve.
  2. Repairing the intake air leak.
  3. Repairing the charging system.
  4. Cleaning the throttle body.
  5. Replacing the power steering pressure switch.

Can a idle control valve be cleaned?

Cleaning an idle air-control valve can keep you from buying a new part, but only certain idle air-control valves can be cleaned. The idle air-control valve must have a spring-operated valve for cleaning to make it work.

What is P0123 code?

P0123 is the generic OBD-II code which indicates that the Engine Control Module (ECM) has seen the TPS circuit A output voltage go above the sensor’s expected voltage specification range.

Share this post