What setting should your water softener be on?
Once you understand exactly what the hardness level is, you will want to set the softener in accordance with the level. For instance, if your hardness is running at a 25, you would set it to 25 on the unit. Most of the time this is done by turning a dial or programming an electric head unit.
How do I adjust my water softener?
How to Set Water Softener Controls
- Press the buttons marked ‘hour’ and ‘minutes’ on your water softener to set the current time.
- Determine what time your household doesn’t use any water.
- Set the time on the regeneration dials, that indicate the time you want the water softener to run.
How many grains of hardness should I set my water softener?
0–3: If your hard water test strip indicates that your water is between 0–3 grains per gallon, your water doesn’t require softening. 3–7: Water between 3–7 gpg is moderately hard, causing spotty dishes and dry skin.
What happens when water softener is set too high?
Soft water provided by a utility does not need additional softening and may cause corrosion issues for your home. Make sure the softener is set to the hardness of your water supply. If the hardness is set too high, the softener will cost more to operate and waste water, costing you extra money.
How do I adjust my water softener to use less salt?
Another method for adjusting the salt dose or the amount of salt used during a water conditioner backwash/regeneration cycle [on some water softener models] involves adjusting the float level inside the brine tank. Explanation of this feature has moved to WATER SOFTENER BRINE TANK FLOAT LEVEL ADJUSTMENT.
What is a good number for water hardness?
Water Hardness Table of Classifications
| grains per gallon (gpg) | milligrams per liter (mg/L) parts per million (ppm) | Water Quality Association Classification |
|---|---|---|
| < 1.0 | < 17.1 | soft |
| 1 to 3.5 | 17.1 to 60 | slightly hard |
| 3.5 to 7.0 | 60 – 120 | moderately hard |
| 7.0 to 10.5 | 120 – 180 | hard |
How to set time of day on Econominder 5600?
Forcing a Manual Regeneration: To manually regenerate the valve, turn the manual regeneration knob clockwise until it reads “REGEN.” 5600 Model Setting the Time of Day: To set the time of day, push the red button and spin the 24-hour gear until the present time of day is visible above the time of day arrow. Setting the Program Wheel:
Where does the water come from in the Econominder 5600?
5600 Econominder Model Setting Time of Day & Initiating a Manual Regeneration Service: Hard water enters unit at valve inlet and flows down through the mineral in the mineral tank. Conditioned water enters center tube through the bottom distributor, then flows up through the center tube, around the piston, and out the outlet of the valve.
How do you set program Wheel on Econominder?
Setting the Program Wheel: To set the program wheel, lift the “people” dial and rotate it so that the number of people in the household is aligned with the household grains per gallon water hardness. Release the dial and check for firm alignment at the setting.
How to install Econominder 5 valve Model 5600?
Model 5600 & 5600 Econominder® 5 Valve Installation and Start-up Procedures 1. Place the softener tank where you want to install the unit. NOTE:Be sure the tank is level and on a firm base. 2. During cold weather it is recommended that the installer warm the valve to room temperature before operating. 3.