Common questions

What is the metal plate in the bathtub for?

What is the metal plate in the bathtub for?

Look inside the wall of the tub, just underneath the faucet and locate the round metal circle. This is the tub’s overflow valve cover, or overflow plate, which allows excess water to drain out instead of spilling over the tub wall. This is the actual drain hole through which water drains out.

Can you replace tub overflow?

Installing a new tub waste-and-overflow can be a bit of a project, so be prepared. If you have a slab foundation there might be an access panel that allows you to work from behind the tub. If there isn’t one already, there you may need to cut one in before you can get the old waste-and-overflow out and the new in.

How do you cap off a bathtub overflow?

You could put a piece of Saran Wrap over the whole thing and the water would probably hold it in place after the water rises over it. You might take the overflow mechanism off the tub and try to fit a rubber gasket behind it, with a hole for the drain actuator, to effectively seal the overflow.

How does a bathtub overflow plate work?

Traditional. A traditional overflow consists of a hole cut into the tub to accommodate a drain that installs on the inside and outside walls which collect excess water and sends it down a tub drain to a P-trap.

What is the overflow on a bathtub?

Tub overflows are located a few inches below the rim to allow the water to rise to a level that submerges the majority of the bather’s body. An opening is cut along the interior of the bathtub to divert extra water between the walls and send it down the tub drain.

What is a trip lever?

A trip lever drain is a type of mechanism that is found in many bathtub designs. Essentially, the trip lever works as part of an apparatus that allows the stopper to be opened or closed, making it possible to retain water in the tub or release the water into the drain.

How do you cover a bathtub overflow yourself?

If the cup is too small, wrap a rope or few rubber bands around it. Another great DIY bath drain cover idea is to use a toilet plunger. You can use it as a makeshift plug for your bathtub drain. First, clean the rubber end using some soap water and then put it over the drain.

How do you remove an overflow plate from a bathtub without screws?

To remove it, place your thumbs at the bottom of the cover plate and press gently upward until the plate snaps free of the underlying mount and pops off in your hand. Depending upon whether you’re troubleshooting, cleaning or upgrading, you can snap the same cover plate or a new one over the same mount.

https://www.youtube.com/watch?v=_XDG8HVO3VU

Share this post