How do you nail cedar siding?
Bevel siding should be face nailed to studs with 1-1/4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center. Place nail just above the overlap. Take care not to nail through the overlap of two pieces.
Should you prime both sides of cedar siding?
For best results, fresh siding should be pre-primed on all six sides with a stain-blocking primer and top coated with 100-percent acrylic-latex paint. Alkyd-oil primers are recommended, but one may choose a high-quality latex primer as long as it contains stain blockers.
Does cedar siding need furring strips?
Cedar is a material that needs to be allowed to flex once installed. It is highly recommended that the product be installed over furring stripes that are attached to the studs of a wall. Moisture will effectively be kept from direct contact to the wall as the siding absorbs moisture from the elements.
Can I use galvanized nails in cedar?
Hot-dipped galvanized, aluminum and stainless steel nails are all corrosion-resistant and all can be used to nail Western Red Cedar. Other types of nails, such as electroplated, are not recommended.
Do I need to stain back of cedar siding?
High-quality paint or stain, properly applied, should last five to seven years, and as many as 10, depending on weather conditions and if you maintain the siding. However, you may need to reapply a clear-coat stain every two years. If new cedar siding requires a finish, apply to individual shakes before installation.
Can you staple cedar siding?
The Cedar Shake & Shingle Bureau prefers the use of nails, however if you choose to use staples they must be stainless steel Type 316 in locations within fifteen (15) miles of salt water. For locations outside of the salt water zone – stainless steel staples Type 304 or Type 316 must be used.
How do you fill nail holes in cedar siding?
Filling Nail Holes Holes in wood trim are best filled with wood filler. Nail holes in exterior surfaces, just as with cracks or gaps, can be dealt with using a good caulking. Take the time before you apply any paint on your next project to fill all of the gaps, cracks, and nail holes.
Can you put Hardie over existing siding?
It works really well when being placed over almost any surface. But if you’re considering using another type of siding for instance, fiber cement siding or James Hardie siding you may have the same options. This type of siding can be placed over some existing siding but most will not be good.
How do you install siding?
Steps Install horizontal siding, such as aluminum or vinyl by hanging the underlayment and installing the trim. Add the corner posts, using two nails in the upper slots to suspend them. Place the footer, which is the piece of trim that is at the bottom of each exterior wall, as starter strip of siding will slide into this.
How do you install cedar shake shingles?
Start at the bottom of the wall at one end. Align the thick, lower edge of a cedar shake at the lower edge of the siding or shear wall. Align one of the vertical edges at the edge of the trim or corner of the wall. Attach the shake with a pair of 5d galvanized box nails and a shingle hatchet or hammer.