Other

How do you install a ballast resistor coil?

How do you install a ballast resistor coil?

Strip the end of the positive wire from the ignition, and connect it to the positive end of the resistor. From the other terminal on the resistor a wire goes to the positive on the coil. Make sure to attach securely to the connecting terminal, by wrapping the wire around the post and tightening with a screwdriver.

How do you install an ignition ballast resistor?

Connecting a ballast resistor is a fairly straightforward project, but you will want to pay attention to the wiring.

  1. Step 1: Determine if Ballast Resistor Is Needed.
  2. Step 2: Locate Ballast Resistor along Firewall.
  3. Step 3: Drill Holes for Securing Resistor.
  4. Step 4: Install Ballast Resistor.
  5. Step 5: Connect Wires to Positive.

Where do you put a ballast resistor?

Note: Ballast resistors are usually located bolted to the firewall if your distributor and/or coil is at the rear of the engine. If your distributor is located near the front or side of the engine in the case of an inline-4 cylinder, then it’s probably right near the ignition coil or distributor.

Where to Mount Mallory hyfire ignition control unit?

The HyFire®Ignition can be mounted in most positions, except directly upside down (if upside down, moisture or water cannot escape). It can be mounted in the engine compartment as long as it is away from direct engine heat sources. It is not recommended to mount the unit in an enclosed area such as the glove box.

When did Mallory start making ignition plugs for cars?

Since 1925, Mallory has been a leading manufacturer of automotive ignition products. From the original Ford V8 to modern coil on plug applications, Mallory has been there for it all and will continue to be with ever-expanding ignition products, both new and old. 3-wire for ignition box.

What kind of wire to use for Mallory Unilite?

Just simply click an image below for the correct instructions pack that would be supplied with your Mallory distributor or for just a simple wiring diagram click the . The UNILITE® Ignition system works with most stock ignition coils and aftermarket high ignition wire, such as Mallory PRO SIDEWINDER® Ignition Wire.

What kind of spark plug do I need for Mallory hyfire?

A good quality, helically wound wire and proper routing are required to get the best performance from your ignition, such as the Mallory Pro Sidewinder Ignition Wire. Note: Solid Core spark plug wires cannot be used with the HyFire®Ignition.

Share this post