How do I restore config file in Brocade switch?

How do I restore config file in Brocade switch?

In the CommandCentral Storage Console, display the Switches Summary (Managing > SAN > Switches.) In the table, click the name of the Brocade switch whose configuration you want to restore. In the drop-down list in the switch’s Overview pane, click Restore Switch Configuration and click Go.

How do I download config files from Brocade switch?

Answer. Use WinSCP to download the file or use the FTP get sub command to move the file from the switch to the FTP server. You will need the root password for the Brocade switch to get the file you need.

What is Configupload in Brocade?

Use this Service Template to execute ‘configupload’ command on Brocade FC switches; typically configupload is used to backup the switch configuration to a remote server. ‘configupload’ is executed via ssh rather than ftp when using this service template.

How do you backup a switch?

Connect to the device, either via console cable, Telnet or SSH. 3. Log in > Go to enable mode > issue a “copy running-config tftp”* command > Supply the IP address of the TFTP server > Give the backup file a name. Note: You can also use startup-config to copy the config saved in NVRAM rather than the running-config.

How do I backup my brocade config?

Backing up a Brocade switch

1. Establish a putty session to the switch and login as normal.
2. Enter the command configupload.
3. At the protocol selection prompt choose the protocol appropriate for you FTP server.
4. At the IP Address prompt enter the IP address of the FTP server Server Name or IP Address [host]: 10.10.10.5.

How do I get brocade Supportsave?

Answer

1. Log on to the switch as admin using telnet or ssh.
2. At the command prompt type: supportsave.
3. You are prompted as: a) the IP address of your FTP server.
4. The files generated by this command are compressed before being sent off the switch. You can then compress these files together before sending to IBM Support.

How do I enable FTP on my Brocade switch?

How do I backup my Brocade SAN switch configuration?

How do I copy files to a TFTP server?

To initiate transfers of configuration files to or from a TFTP server using the CLI, enter one of the following commands: copy startup-config tftp tftp-ip-addr filename – Use this command to upload a copy of the startup configuration file from the Layer 2 Switch or Layer 3 Switch to a TFTP server.