Can you install a toilet seat yourself?

Can you install a toilet seat yourself?

Installing a new toilet seat is an easy DIY project. Whether you’re replacing yours because it’s old, or because you just want a new style, all you need are some basic tools and a few minutes. Unbolt the old seat, then pop the new one in place using the hardware included in your new toilet seat’s box.

Is it easy to fit a soft close toilet seat?

A bottom-fixing soft close toilet seat is a little tiresome to install than a top fixing one. You will needed to hold a wingnut underneath the toilet bowl with one hand and screw in the bolt with your other hand using a screwdriver. All the same, it is way better than a slamming toilet seat.

Are toilet seat fittings standard?

No, there isn’t a standard size for all toilet seats, due to a variety of toilet styles. There are key measurements that you will need, even though most seats are adjustable to fit the most common toilet bowl shapes. The measurements are: The distance between the fixing holes – where the screws are.

How do you soft close a toilet seat?

Assembly Instructions Soft Close Toilet Seat. To adjust the speed that the seat and cover fall, remove the hinge pins, rotate them and replace them as in the illustrations to the right. N.B. One hinge pin operates the cover, one operates the seat. It is important to adjust the hinges separately to get the required speed of closure.

Is the hinges on a soft close toilet seat adjustable?

However, not all soft-close toilet seats have adjustable hinges, but you’ll have to remove the seat and inspect the hinges to find out if yours are adjustable. If your soft-close seat isn’t working like it used to and you can’t adjust the hinges, you might have to fix it by replacing the hinge dampers with a new set.

What’s the best way to fit a toilet seat?

Fit the hinge assembly to the seat following the manufacturer’s instructions. Connect the seat to the pan by securing through the holes at the back using the screws supplied. Adjust so that it sits in the correct position. All project content written and produced by Mike Edwards, founder of DIY Doctor and industry expert in building technology.

How do you put a toilet seat back on hinges?

Put the toilet seat back on the toilet bowl. Align the holes in the seat’s hinges with the begs on the toilet bowl. Set the seat back on the hinge pegs in the upright position. If the hinges have a locking mechanism, make sure you push the seat all the way onto the pegs until the hinges snap into place.

Share this post